Mounting and Commissioning
3.3 Commissioning
SIPROTEC, 7SK80, Manual
E50417-G1140-C344-A5, Release date 11.2012
332
Figure 3-25 Module-specific settings
Then, transfer the data to the protection device (see the following figure).
Figure 3-26 Transmitting data
Terminal Test
The system interface (EN 100) is preassigned with the default value zero and the module is thus set to DHCP
mode. The IP address can be set in the DIGSI Manager (Object properties... / Communication parameters /
System interface [Ethernet]).
To Next Page
Loading...
