Siemens A52 - Dialling with number keys; End call; Redial previous numbers

Making a phone call
16
A52 Fox en, A31008-H6250-A1-1-7619 (4. July 2003, 15:54)
© Siemens AG 2002, I:\Mobil\A52_Fox\en\A52_phone.fm
Making a
phone call
Dialling with number
keys
The phone must be switched on
(standby mode).
J
Enter the number (always
with prefix, if necessary
with the international
dialling code).
§Clear§ A short press clears
the last digit, a long press
clears the entire number.
A
Press the Call key. The
phone number displayed
is dialled.
End call
B
Press the End key briefly.
The call is ended. Press
this key even if the person
on the other end of the
line has hung up first.
Set volume
E
You can activate adjust-
ment of the handset vol-
ume with the scroll key (at
the top), but only during a
call.
G Set volume.
If a car kit is used, its volume setting
will not affect the usual setting on
the phone.
Redial previous numbers
To redial the phone number last
called:
A
Press the Call key twice.
To redial other numbers that were
dialled previously:
A
Press the Call key once.
G
Pick out the required
phone number from the
list, then press ...
A
... to dial.
Note
 Store number .........................p. 22
§Options§ Call lists.............................p. 28
§Hold§ Swap/conference ....................p. 18
y menu§ Call menu ..........................p. 20
§Divert§ Divert set ..............................p. 48
International dialling codes................p. 59
Key lock.............................................p. 60
Phone number memo........................p. 60
Microphone off ..................................p. 20
Phone number transmission off/on
(Hide ID)............................................p. 46
Control codes (DTMF).......................p. 58
del
e
tex
t
this
siti
o