Siemens A52 - Master reset; Network

Setup
51
A52 Fox en, A31008-H6250-A1-1-7619 (4. July 2003, 15:54)
© Siemens AG 2002, I:\Mobil\A52_Fox\en\A52_Setup.fm
§Menu§KSetupKSecurityKBarrings
KSelect a function.
Outgo internat. x home barred
International calls are not permitted.
However you can make calls to your
home country when abroad.
All incoming calls
The phone is barred for all incoming
calls (the forwarding of all calls to
the mailbox offers a similar effect).
When roaming
You do not receive calls when you
are outside your home network. This
means that no charges are incurred
for incoming calls.
Status check
The following information can be
displayed after a status check:
p Barring set.
o Barring not set.

Status unknown
(e.g. new SIM card).
Clear all
All barrings are cleared. A password
which the service provider will give
you is necessary for this function.
Phone identity
§Menu§KSetupKSecurity
KSelect a function.
The phone ID (IMEI) is displayed. This
information may be useful for cus-
tomer service.
Alternatively enter in standby mode:
*
# 0 6 #
Master reset
The phone is reset to the default
values (factory setting) (does not
apply to SIM card and network ^kt-
settings).
Alternative input in standby mode:
*
# 9 9 9 9 #
A
Network
§Menu§KSetupKNetwork
KSelect a function.
Line
This function is only displayed if it is
supported by the service provider.
Two independent phone numbers
must be registered on the phone.
Select
Select the currently used phone
number.

Display the current phone
number.
Lock line
(Phone code protected)
You may limit usage to one phone
number.
Note
Settings for phone numbers ..............p. 62
L