Administration
A31003-S2000-M102-3-76A9, 08/07/2009
3-86 Asterisk - OpenStage Family, Administration Manual
administration.fm
Dialing
3.7.3 Dial Plan (V2)
With firmware version V2, OpenStage phones may optionally use a phone-side dial plan. By
means of the dial plan, the phone can infer from the digits entered by the user that a complete
call number has been entered. Thus, the phone can start the dialing process without the user
explicitly having to select a further option such as "dial" or "OK" after entering the last digit. The
standard timer, which is found on the WBM under User menu > Configuration > Outgoing calls
> Autodial delay (seconds), is overridden.
A dial plan consists of rules defining patterns, timeouts and actions to be performed when a
pattern is matched and/or a timeout has expired. The phone can store one dialplan, which can
contain up to 48 different rules.
It is very important that the phone’s dial plan does not interfere with the dial plan in the SIP
server, PBX, or public network.
The dial plan can be created and uploaded to the phone using the DLS (please refer to the De-
ployment Service Administration Manual). The DLS can also export and import dial plans in
.csv format. For details about the composition of a dial plan, please refer to Section 4.4.1, “How
To Set Up And Deploy A Dial Plan”.
The current dial plan, along with its status (enabled/disabled) and error status can be displayed
on the WBM via Diagnostics > Fault trace configuration > Download dial plan file.
To make use of the dial plan facility, the following requirements must be met:
• A correct dial plan must be loaded to the phone.
• In the user menu, Allow immediate dialing must be enabled
• Dial plan enabled must be checked.
Administration via WBM
User menu > Configuration > Outgoing calls > Allow immediate dialing
To Next Page
Loading...
Need help?
General