inbetriebnahme.fm
A31003-S2000-M102-3-76A9, 08/07/2009
Asterisk - OpenStage Family, Administration Manual
2-7
Startup
Quick Start
2.3 Quick Start
This section describes a typical case: the setup of an OpenStage endpoint in an environment
using a DHCP server and the web interface. For different scenarios, cross-references to the
corresponding section of the administration chapter are given.
2.3.1 Access the Web Interface (WBM)
1. Open your web browser and enter the appropriate URL, which can be an IP address or a
DNS name, for example:
https://192.168.1.15 or http://myphone.phones (firmware V2)
For configuring the phone’s DNS name, which is possible which firmware V2, please refer
to Section 3.3.6.3, “Customised DNS Name (V2)”.
The phone uses the standard port for HTTPS, 443.
>
Alternatively, the DLS (Deployment Service) administration tool can be used. Its
Plug & Play functionality allows to provide the phone with configuration data by as-
signing an existing data profile to the phone’s MAC address or E.164 number. For
further information, see the Deployment Service Administration Manual.
>
Any settings made by a DHCP server are not configurable by other configuration
tools.
To Next Page
Loading...
Need help?
General