Siemens Desigo PXC5.E003 - Technical Data; Power Supply; Interfaces

6
Siemens Schweiz AG
A6V11646020_en--_b
Smart Infrastructure
2020-07-10
Technical data
Power supply
Operating voltage (24 V~, ⏊, )
AC 24 V -15 / +20 % (SELV / PELV) or
AC 24 V Class 2 (US)
48…63 Hz
Functional ground (US)
Functional earth
The terminal for the functional ground must be
connected on the installation side with the building
grounding system (PE).
Screw terminals for wire cross sections up to
Max. 2.5 mm
2
(14 AWG)
Internal fusing
3.15 A irreversible / non-replaceable
External supply line fusing (EU)
Non-renewable fuse max. 10 A slow-blow
or
circuit breaker max. 13 A
Tripping characteristic B, C, D per EN 60898
or
Power supply with current limitation of max. 10 A
Power consumption (for transformer planning)
Base load
With M-Bus, with KNX
12 VA / 0.5 A
19 VA / 0.8 A
Function data
Hardware information
Processor
NXP i.MX8 DualX
Storage
1 GByte RAM
8 GByte eMMC
Data backup in the event of power failure
Energy reserve (Supercap) to support real-time clock (7 days).
Energy reserve can be extended to min. 1 month using optional battery CR2032
(Battery safety requirement and specification for CR2032 according to IEC 60086-4 or UL1642.
Battery must be rated for ambient temperature 70 °C (158 °F))
Data available if stored to flash memory. Occurs every 5 minutes.
Interfaces
Ethernet interface
Plug
2 x RJ45, shielded
Interface type
10Base-T / 100Base-TX, IEEE 802.3 compatible
Bit rate
10/100 Mbps, autosensing
Protocol
BACnet on UDP/IP and HTTPS on TCP/IP
Cabling (in-house cabling only), cable type
10 Mbps: Min. CAT3, shielded cable is recommended
100 Mbps: Min. CAT5, shielded cable is recommended
Cable length
Max. 100 m (330 ft)
Screw terminals, plug-in
Cu-wire or Cu-strand with wire end sleeve
1 x 0.6 mm ∅ to 2.5 mm
2
(22 to 14 AWG)
or 2 x 0.6 mm ∅ to 1.0 mm
2
(22 to 18 AWG)
Cu-strand without wire end sleeve
1 x 0.6 mm ∅ to 2.5 mm
2
(22 to 14 AWG)
or 2 x 0.6 mm ∅ to 1.5 mm
2
(22 to 16 AWG)