Siemens DPU User Manual

CHAPTER 2 | DEVICE PROGRAMMING UNIT USER’S MANUAL
PROGRAMMING 11
1b
6
5
1a
DPU DB-3S BASE
ADAPTOR
P/N 515-033925
BOTTOM
OF DPU
*NOTE:
The prong on the same side
of the programming plug as the
locating tab goes into the black
banana jack.
*LOCATING
TAB
PROGRAMMING
PLUG
BLACK
BANANA
JACK
To Program/Test A Compatible Series ILI/ILP
Detector, connect the DPU to the DB-3S Base
Adaptor:
To Remove Detector Head:
• Insert programming plug of P/N 515-033925 into
the red and black banana jacks in the cable
compartment in the bottom of the DPU.
• Align notch in detector cover to raised surface
on outer ring of base.
• Push detector head into base and rotate
clockwise to make electrical connections. The
detector automatically stops and locks into
place.
• Push detector head into the base while rotating
the detector head counterclockwise. Continue
to rotate counterclockwise until stop is
reached.
CABLE P/N 555-133891
WITH ALLIGATOR CLIPS
BOTTOM OF DPU
O
R
GBL
K
BLK
G
R
N
O
R
GRE
D
RED
A
L
L
C
O
N
N
E
C
T
IO
N
S
A
R
E
P
O
W
E
R
L
IM
IT
E
D
-
E
A
R
T
H
G
N
D
+
HTRI-M
To Program/Test HTRI-M/TRI-B6M Devices:
• Insert the programming plug in one end of cable
P/N 555-133891 into the red and black banana
jacks in the cable compartment in the bottom of
the DPU.
• Using the two alligator clip adaptors provided on
the programming plug, connect the other end of
cable P/N 555-133891 to the red and black wires
of the HTRI/TRI device.
* LOCATING TAB
PROGRAMMING
PLUG
BLACK
BANANA
JACK
*NOTE:
When programming or testing MXL
and FS-100 devices, the prong on
the same side of the programming
plug as the locating tab goes into
the black banana jack.

Siemens DPU Specifications

General

Brand	Siemens
Model	DPU
Category	Motherboard
Language	English