Siemens et 200sp - Product overview; 2.1 Properties

Parameters/address space
3.3 Address space
Server module (6ES7193-6PA00-0AA0)
Manual, 03/2015, A5E03575337-AB
13
3.3.2
Input data for interface modules with maximum 32 I/O modules
Configuration with enabled status detection of the supply voltage L+ (4 bytes of input data)
You can read out the following status for each I/O module of the ET 200SP in the input data
(byte 0 to 3):
● Supply voltage L+ present/missing or I/O module available/not available (4 bytes)
Figure 3-3 Supply voltage L+ missing or I/O module not available (4 bytes); feedback voltage not
available
Configuration with enabled status detection of the supply voltage L+ and enabled status detection of
the feedback voltage (8 bytes of input data)
You can read out the following status for each I/O module of the ET 200SP in the input data
(byte 0 to 7).
● Supply voltage L+ present/missing or I/O module available/not available (4 bytes)
● Feedback voltage present/missing (4 bytes)
Figure 3-4 Configuration with enabled status detection of the supply voltage L+ and enabled
status detection of the feedback voltage (8 bytes of input data)
Note
•
An inserted or missing server module always signals bit=0 for the slot.
•
If the server module is missing, the input data is invalid.
•
For I/O modules without feedback voltage monitoring, the bit for the feedback voltage is
the same as the bit for the missing supply voltage L+.