Survey of operating functions
Autocalibration
C
* 94 Switch over between mg/m
3
and ppm
** 20 Autoranging on/off
2 Display measuring range
* 1 Change measuring range
Display and switch over measuring ranges, switch over display
A
* 8 Calibrate senstitivity to setpoint
* 7 Adjust sensitivity setpoint
45 Display purging times
* 17 Switch over from total calibration to individual calibration
6 Display sensitivity setpoint
* 5 Calibrate zero
Calibration of measuring ranges
B
** 44 Set purging times
43 Display time between two “autocals”
** 22 "autocal" on/off
** 42 Set time between two “autocals”
** 41 Set time up to first “autocal”
** 40 Trigger single “autocal”
A-7
To Next Page
Loading...
