** 48 Signal contact at start/end of “autocal”
** 47 Set sample gas time between zero and sensivity calibrations; set calibrations
to be omitted
46 Display time up to next “autocal”
Autocalibration (continued)
C
* 36 Display, set sample gas pressure
9 Display limits
** 23 Limit monitoring on/off
** 19 Set limit
** 18 Set limits to upward or downward exceeding
** 32 Display, enter actual temperature and setpoint temperature of heated line
** 31 Display, enter actual temperature and setpoint temperature of pump
** 30 Display, enter actual temperature and setpoint temperature of oven
* 35 Display, set H
2
pressure
** 34 Display, set max. temperature deviation
** 33 Display, enter actual temperature and setpoint temperature of sample gas probe
* 38 Enter tolerance for sample gas pressure
* 37 Enter tolerance for hydrogen pressure
Temperatures, pressures, flow, limits
D
*** 39 Probe and/or heated line present/not present
A-8
To Next Page
Loading...
