To Next PageTo Next Page
Need help?Do you have a question about the Siemens FC300 and is the answer not in the manual?
General| Manufacturer | Siemens |
|---|---|
| Category | Measuring Instruments |
| Measurement Principle | Coriolis |
| Fluid Temperature | -50°C to +200°C (-58°F to +392°F) |
| Process Connection | Flanged, threaded, or sanitary |
| Outputs | 4-20 mA HART, pulse, frequency, alarm, PROFIBUS PA, Foundation Fieldbus |
| Enclosure | Aluminum, Stainless Steel |
| Protection Rating | IP67 |
| Operating Temperature Range | -40°C to +60°C (-40°F to +140°F) |
| Accuracy | ±0.1% of flow rate (liquid), ±0.5% of flow rate (gas) |
Information to maintain device status and ensure safe operation.
Specific qualifications and requirements for operating in hazardous environments.
Lists the key features and capabilities of the device.
Guidelines for selecting an appropriate and safe installation location.
Instructions for correctly mounting the device to ensure functionality and safety.
Detailed steps for installing the sensor and transmitter components.
Steps for connecting the DSL, transmitter, power supply, and I/Os.
Instructions for commissioning the device via the local display (HMI).
Procedures for commissioning the device using SIMATIC PDM software.
Detailed instructions on how to monitor and operate the device using the local display (HMI).
Details the process values that are updated and available for measurement.
Function to force flow signals to zero when flow is below a predefined value.
General safety precautions to be observed during device maintenance and inspection.
Safety precautions to be taken when performing maintenance and repair work.
Explanation of symbols used in the display for device status.
List of alarm IDs, possible causes, and corrective actions for troubleshooting.
Guidance on troubleshooting common operational issues with the device.
Using SIMATIC PDM for device diagnosis and analysis.
Details on measurement accuracy and reference conditions for the device.
Details on digital output, relay output, and current output configurations.
Default settings for various parameters based on sensor dimensions.
Default settings for sensor-related parameters like flow direction and noise damping.
Default settings for process values including units, custom units, and limits.
Detailed breakdown of the HMI menu for configuring inputs and outputs.
Detailed breakdown of the HMI menu for dosing application setup.
