WARNING
Installation in hazardous areas
When making electrical connections, observe the national statutes and provisions for
hazardous areas valid for the particular country.
● Operational safety regulations
● Directive for the installation of electrical systems in hazardous areas DIN EN 60079-14
5.2.3 Connecting the multiple plug to the sensor
When connecting/disconnecting the pipes, the cable must be mechanically connected in order
to prevent the liquid from penetrating into the electrical multiple plug on the sensor.
Mount the multiple plug and tighten the glands for optimum sealing.
5.2.4 Transmitter power supply and I/Os connection
5.2.4.1 Step 1: Connecting the DSL and the transmitter
The following only applies to remote configurations.
Wiring DSL (sensor) and transmitter (M12)
The DSL is provided with a preformed cable terminated with M12 style stainless steel weather-
proof plugs.
Connecting
5.2 Connecting MASS 2100/FC300
MASS 2100 & FC300 (FCT030)
64 Operating Instructions, 06/2017, A5E39789040-AA
To Next Page
Loading...
