6. Carefully push display back into housing. Use a small screwdriver or blade to open the
three retaining clips within the transmitter when pushing the display home.
7. Remove O-ring from lid.
8. Reinstall display cover until mechanical stop. Wind back lid by one turn.
9. Mount O-ring by pulling it over the display cover and turn display cover until you feel friction
from the O-ring on both sides. Wind display cover further by one quarter of a turn to seal
on the O-ring.
10.Reinstall and tighten lid lock screw.
4.2.2.3 Wall mount housing transmitter
CAUTION
Opening lid
Care must be taken when opening the lid to avoid the lid falling.
Installing/mounting
4.2 Installation instructions
MASS 2100 & FC300 (FCT030)
54 Operating Instructions, 06/2017, A5E39789040-AA
To Next Page
Loading...
