Siemens FC300 - Resets; Firmware Update; Communication; B.11 Resets

Table B-42 Self test
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.10.1 Display Test Display test User
B.11 Resets
Table B-43 Reset
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.11.1 Restore ordered config‐
uration
Reset all parameters to custom‐
er ordered settings
Cancel
● Cancel
● Ok
User
3.11.2 Device restart Restart the device without dis‐
connecting the power
Cancel
● Cancel
● Ok
User
B.12 Firmware update
Table B-44 Firmware update
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.11.1 Firmware update Update the firmware Expect
B.13 Communication
Table B-45 Communication
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
4.1 Service channel (USB)
4.1.1 USB mode Returns the information which
USB mode is currently activated.
USB communi‐
cation
● USB
communicatio
n
● Mass storage
4.1.2 Auto mode Defines if the device is automat‐
ically connected to a PC as MSD
when USB cable is connected.
Disabled
● Disabled
● Enabled
4.1.3 MSD connect Connects/disconnects the trans‐
mitter as mass storage device to/
from PC.
Disconnect
● Disconnect
● Connect
4.2 HART Channel 1
Default settings
B.13 Communication
MASS 2100 & FC300 (FCT030)
466 Operating Instructions, 06/2017, A5E39789040-AA