6. Connect wires to terminals using wiring tool, wall mount transmitter.
PROFIBUS DP/PA
④ In + (B)
⑤ In - (A)
⑥ Out + (B)
⑦ Out - (A)
7. Tighten cable gland.
5.2.4.6 Step 3: Connecting the power supply
1. Flip open power supply terminal protection cover.
2. Remove cap and ferrule from cable gland and slide onto cable.
3. Push cable through open gland and cable path.
4. Restore ferrule and tighten cap to lightly hold cable in place.
Connecting
5.2 Connecting MASS 2100/FC300
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 75
To Next Page
Loading...
