Siemens FC300 - Wizards

2 Select zero point adjust‐
ment type
Auto, Manual
3-4 Configure Configure duration and limits
5 Auto Adjust Zero point Cancel, Start (progress, result, standard deviation and offset)
6 In progress The progress bar is shown
7 Result Information on success or failure of zero point adjustment
8-9 View result Standard Deviation and Offset values
*: Pressing Cancel will bypass the Zero Point Adjustment and go to view 10.
Note
View result
Standard Deviation and Offset values are only updated if the zero point adjustment was
completed successfully. Otherwise the previous values are used.
6.3.4.5 Wizards
The HMI wizard graphics show an overview of each HMI wizard and of the keys used to
navigate through the wizards. In the upper left corner of each view the wizard name (for
example "Process Values") and the step name (for example "Unit") of the wizard is shown. In
the upper right corner the view number (for example 5 of 18 in the Process Values wizard) is
shown.
2
1 3
① Wizard name
② Step name / Parameter name
③ View number / Total views in wizard
The purpose of the HMI wizards is to guide you through a quick set-up of various parameters.
The following HMI wizards are available:
● Quick Commissioning
● Process Values
● Zero Point Adjustment
● Inputs/Outputs
● Gas Application
● Pulsating Flow
● Dosing Application
Commissioning
6.3 Local commissioning
MASS 2100 & FC300 (FCT030)
100 Operating Instructions, 06/2017, A5E39789040-AA