Siemens FC300 - Security; B.14 Security

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
4.3.9.14 Totalizer 3 unit Select Totalizer 3 unit for the
communication interface. Unit is
not applied at Local User Inter‐
face.
SL SL, Nm³, SL, Sft³,
Sm³
User
4.3.10 Damping
4.3.10 Damping value Define the damping filter time
constant.
0.0 s 0 to 100.0 s User
4.3.10.1 Process values (1) Select the process values for
damping
● Mass flow
● Volume flow
● Standard
volume flow
● Standard
density
● Totalizer 1
● Totalizer 2
● Totalizer 3
● Dosing
● Density
● Medium
temperature
User
B.14 Security
Table B-46 Access Management
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
5.1 Change user PIN Code Change PIN code used to ac‐
cess the user access level.
Expert
5.2 Change expert PIN
Code
Change PIN code used to ac‐
cess the expert access level.
Expert
5.3 Recovery ID If you forgot the PIN contact Sie‐
mens customer support and re‐
quest a PUK by providing the
Recovery ID.
Expert
5.4 4 PIN recovery Enter Pin Unlock Key (PUK) you
got from Siemens customer sup‐
port. Afterwards the default PINs
as indicated in the manual are
valid.
Expert
5.5 Activate user PIN Do you wish to enable the ac‐
cess control?
Expert
5.6 Deactivate user PIN Do you wish to disable the ac‐
cess control?
Expert
Default settings
B.14 Security
MASS 2100 & FC300 (FCT030)
476 Operating Instructions, 06/2017, A5E39789040-AA