Siemens FC300 - Commissioning with PDM

2 Dosing Mode Select the dosing mode to control the valve(s) on the output
3 Dosing options Setup instructions for the selected dosing mode
4-6 Configure Output Configure the output to control the valves
7 Process Value Select the process value
8-15 Configure recipe Configure the recipe (valve control and fault handling)
16 Active Recipe Select a dosing recipe
*: Set Operation Mode to Status Mode and set Status Mode to control Primary Valve or
Secondary Valve.
**: Set Status Mode to Primary Valve or Secondary Valve.
***: Set Operation Mode to Dosing Control.
For dosing setup, see Valve control configuration (Page 157).
6.4 Commissioning with PDM
For commissioning with SIMATIC PDM, see separate function manual for MODBUS, HART
or PROFIBUS.
6.4.1 Operating via SIMATIC PDM
SIMATIC PDM is a software package used to commission and maintain process devices.
See also
www.siemens.com/simatic-pdm (www.siemens.com/simatic-pdm)
Commissioning
6.4 Commissioning with PDM
MASS 2100 & FC300 (FCT030)
110 Operating Instructions, 06/2017, A5E39789040-AA