① Long TAG Describes the measurement point and is shown in all operation views.
Can be changed via the menu "Long TAG" (3.1.1).
② View number Shows the operation view number. The number refers to the view num‐
ber configured in the menu "Setup" → "Display".
③ Alarm icon Indicates an active alarm. Shows the alarm class, see Fault codes and
corrective actions (Page 188).
Only shown if an alarm is active.
④ Alarm status text Describes the alarm. Only shown if an alarm is active.
7.2.1.4 Measurement views
Measurement views
Single value
① Process value The user-defined process value to be displayed is configured in menu
"View" (1-6) located at "Setup" → "Display"
Operating MASS 2100/FC300 with FCT030
7.2 Operating instructions
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 119
To Next Page
Loading...
