Siemens FC300 - Page 120

Three values
2
4
6
1
3
)&66
5
① First process value The user-defined process value to be displayed is configured in menu
"View" (1-6) located at "Setup" → "Display"
② Lower Limit Alarm The lower limit of the bar graph is defined by the lower alarm limit of
the selected process value.
③ Upper Limit Alarm The upper limit of the bar graph is defined by the upper alarm limit of
the selected process value.
④ Bargraph Shows the first process value in relation to its configured maximum
and minimum limits (Upper Alarm Limit and Lower Alarm Limit for the
selected process value).
⑤ Second process value The user-defined process value to be displayed is configured in menu
"View" (1-6) located at "Setup" → "Display"
⑥ Third process value The user-defined process value to be displayed is configured in menu
"View" (1-6) located at "Setup" → "Display"
Note
Bargraph
The bargraph limits are defined as the lower and upper alarm values.
One value and bargraph
2
4
1
3
)&66
① Process value The user-defined process value to be displayed is configured in menu
"View" (1-6) located at "Setup" → "Display"
② Lower Limit Alarm The lower limit of the bar graph is defined by the lower alarm limit of the
selected process value.
③ Upper Limit Alarm The upper limit of the bar graph is defined by the upper alarm limit of the
selected process value.
④ Bargraph Shows "1st Process value" in relation to its configured maximum and
minimum limits (Upper Alarm Limit and Lower Alarm Limit for the selected
process value).
Operating MASS 2100/FC300 with FCT030
7.2 Operating instructions
MASS 2100 & FC300 (FCT030)
120 Operating Instructions, 06/2017, A5E39789040-AA