7.2.1.1 Display view structure
There are three view types:
● Operation view
The operator view shows up to six operation views (Page 118). The operation views are
fully configurable to show different process values in different operation view types.
Depending on the operation view type configuration the view is either measurement view
or alarm view.
– Measurement view: Displays the measurement values, see Operation view (Page 118).
– Alarm view: Displays the active alarms in a list, see Operation view (Page 118).
– Operating view: Enables the totalizer reset and the dosing control, see Operation view
(Page 118).
– Diagnostic view: Displays six configurable measurement/diagnostic values, see
Operation view (Page 118).
● Navigation view
The Navigation view (Page 127) shows the menus and parameters. The navigation view
is used to navigate through the menus and parameters in the device.
● Parameter view
The Parameter view (Page 129) can be entered from the navigation view. The parameter
view is used to view and edit the parameters.
Navigating the operation view
Browse the operation views and menu items using the control buttons as follows:
Table 7-1 Measurement view
Key Function
No functionality
Go to the previous menu in the operation view
Go to the next menu in the operation view
Enter the navigation view
Table 7-2 Alarm view level 1
Key Function
No functionality
Go to the previous menu in the operation view
Go to the next menu in the operation view
Enter alarm view level 2
Operating MASS 2100/FC300 with FCT030
7.2 Operating instructions
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 113
To Next Page
Loading...
