Siemens FC300 - Diagnostic Views

Alarm acknowledgement
There are two ways to have the alarms removed from the alarm list.
● Manual: The alarm remains in the alarm list until the alarm is manually acknowledged (ack.).
The time of the acknowledgement is shown in the history log.
● Auto: The alarm is removed from the alarm list when the cause is removed (going)
7.2.1.7 Diagnostic views
Diagnostic view
Six Diagnostic Values
4
3
5
1
6
2
① First process/diagnostic
value
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
② Second process/diag‐
nostic value
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
③ Third process/diagnostic
value
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
④ Fourth process/diagnos‐
tic value
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
⑤ Fifth process/diagnostic
value
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
⑥ Sixth process/diagnostic
value
The user-defined process value to be displayed is configured in
menu "View" (1-6) located at "Setup" → "Display"
Operating MASS 2100/FC300 with FCT030
7.2 Operating instructions
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 125