Reprogram, activate, deactivate codes
M
*** 78 Suppression of negative measured values
*** 77 Suppression of brief noise signals
69 LED check, software No.
*** 68 RESET
*** 99 Switch analyzer on/off
96 Display ∆ zero calibration
* 92 Display warnings and brief errors
*** 79 Pause
*** 67 Ignite flame
*** 65 STANDBY
*** 62 Reproduce internal values on analog signal, channel 1
*** 50 Reprogram, activate/deactivate codes
Test functions, RESET, switch-off (continued)
L
*** 57 Store user-specific data
*** 55 Load user-specific data
*** 53 Load basic factory-set data
** 49 Switch valves individually
* 29 Measure during warming-up phase
A-10
To Next Page
Loading...
