** 33 Display, enter actual temperature and setpoint temperature of sample gas probe
* 5 Calibrate zero
2 Display measuring range
* 1 Change measuring range
A
B
D
A
** 32 Display, enter actual temperature and setpoint temperature of heated line
D
** 12 Define full-scale values of measuring ranges
G
** 11 Define start-of-scale values of measuring ranges
G
9 Display limits
D
* 8 Calibrate senstitivity to setpoint
B
* 7 Adjust sensitivity setpoint
B
6 Display sensitivity setpoint
B
** 31 Display, enter actual temperature and setpoint temperature of pump
D
** 30 Display, enter actual temperature and setpoint temperature of oven
D
* 29 Measure during warming-up phase
L
** 24 Set current output
F
** 23 Limit monitoring on/off
D
** 22 "autocal" on/off
C
** 21 Measured-value memory on/off
F
** 20 Autoranging on/off
A
** 19 Set limit
D
** 18 Set limits to upward or downward exceeding
D
* 17 Switch over from total calibration to individual calibration
B
15 Display compensated background current (zero calibration)
I
** 14 Set dynamic time constant T
D
(dynamic noise rejection)
E
** 13 Set time constant T
90
E
A-11
To Next Page
Loading...
