** 44 Set purging times
* 36 Display, set sample gas pressure
* 35 Display, set H
2
pressure
** 34 Display, set max. temperature deviation
D
D
C
D
43 Display time between two “autocals”
C
** 42 Set time between two “autocals”
C
** 41 Set time up to first “autocal”
C
** 40 Trigger single “autocal”
C
** 39 Probe and/or heated line present/not present
D
* 38 Enter tolerance for sample gas pressure
D
* 37 Enter tolerance for hydrogen pressure
D
*** 65 STANDBY
L
*** 62 Reproduce internal values on analog signal, channel 1
L
61 Display measured variables
I
60 Display internal values
I
*** 57 Store user-specific data
L
*** 55 Load user-specific data
L
*** 53 Load basic factory-set data
L
** 51 Select number of valid measuring ranges
G
*** 50 Reprogram, activate/deactivate codes
M
** 49 Switch valves individually
L
** 48 Signal contact at start/end of “autocal”
C
** 47 Set sample gas time between zero and sensivity calibrations;
set calibrations to be omitted
C
46 Display time up to next “autocal”
C
45 Display purging times
C
A-12
To Next Page
Loading...
