Siemens Gigaset DL500A - Appendix; Caring for Your Telephone; Contact with Liquid; Insert Strips

104
Appendix
Gigaset DL500A / GRC EN / A31008-N3103-T101-1-7619 / appendix.fm / 31.08.10
Version 4, 16.09.2005
Appendix
Caring for your telephone
Wipe the base station, charging cradle and
handset with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause static.
Contact with liquid
If the handset has come into contact with
liquid:
1. Switch off the handset and remove the
battery pack immediately.
2. Allow the liquid to drain from the hand-
set.
3. Pat all parts dry, then place the handset
with the battery compartment open and
the keypad facing down in a dry, warm
place for at least 72 hours (not in a mic-
rowave, oven etc.).
4. Do not switch on the handset again un-
til it is completely dry.
When it has fully dried out, you will normally
be able to use it again.
Insert strips
Blank insert strips for the function keys can
be found on the enclosed CD.
Specifications
Power consumption of the base
General specifications
Pin connections on the fixed line
telephone jack
!
In idle status Approx. 3.6 W
During a call Approx. 4.3 W
Interfaces analogue fixed line, Ether-
net, Bluetooth
DECT standard Supported
GAP standard Supported
No. of channels 60 duplex channels
Radio frequency
range
1880–1900 MHz
Duplex method Time multiplex,
10 ms frame length
Channel grid 1728 kHz
Bit rate 1152 kbit/s
Modulation GFSK
Language code 32 kbit/s
Transmission power 10 mW, average power per
channel
Range (handsets) up to 300 m outdoors,
up to 50 m indoors
Power supply 230 V ~/50 Hz
Environmental con-
ditions for operation
+5°C to +45°C, 20% to
75% relative humidity
Dialling mode DTMF (tone dialling)
Protocols DECT, GAP, DHCP,
NAT Traversal (STUN), HTTP
1unused
2unused
3a
4b
5unused
6unused
3
2
1
4
5
6