Siemens Gigaset DL500A - Operating When on the Move (Remote Operation)

66
Operating the base's answering machine
Gigaset DL500A / GRC EN / A31008-N3103-T101-1-7619 / answering_m.fm / 31.08.10
Version 4, 16.09.2005
Operating when on the move
(remote operation)
You can check and activate your answering
machine from any other telephone (hotel,
pay phone etc.).
Prerequisites:
u You have set a system PIN other than
0000 (page 91).
u The phone you are using for remote oper-
ation has tone dialling (DTMF) i.e., you
hear different tones when you press the
keys. Alternatively, you can use a code
transmitter (available from retailers).
Calling the answering machine and
playing messages
~ Dial your own number.
9~ When you hear your announce-
ment: Press 9.
The announcement is aborted.
~ Enter system PIN.
You are informed whether any new mes-
sages have been recorded. The messages are
now played back. You can now operate the
answering machine with the keypad.
The following keys are used for operation:
A During time stamp playback:
Skip to previous message.
During message playback:
Skip to the start of the current
message.
B Stop playback. Press again to
resume.
After a pause of approx. 60 sec-
onds, the connection is ended.
3 Go to the next message.
D Repeat the last five seconds of
the message.
0 During message playback:
Delete current message.
: Change the status of a previ-
ously played back message to
"new".
The next message starts to play.
The remaining memory is
announced at the end of the last
message.
Cancelling remote operation
¤ Press the end call key or replace the
receiver.
Activating the answering machine
¤ Phone home and let the phone ring
until you hear: "Please enter PIN"
(approx. 50 seconds).
~ Enter system PIN.
Your answering machine is activated. It tells
you how much memory is left.
The messages are played.
The answering machine cannot be deacti-
vated remotely.
If you enter an incorrect PIN or input is tak-
ing too long (more than ten seconds), the
connection is ended. The answering
machine will remain deactivated.
Please note
Remote operation via a GSM mobile is
only possible if the mobile and the GSM
mobile connection transmit DTMF sig-
nals.
Please note
The answering machine will terminate
the connection under the following cir-
cumstances:
u An incorrect system PIN has been
entered.
u There are no messages in the answer-
ing machine.
u After the remaining memory has
been specified.