72
Setting the alarm clock
Gigaset DL500A / GRC EN / A31008-N3103-T101-1-7619 / add_features.fm / 31.08.10
Version 4, 16.09.2005
Information about the appointment/anni-
versary is displayed. A missed appointment
is shown with the appointment name
(
¢ page 70), a missed anniversary with
name and surname. The date and time is
also given.
§Delete§ Delete appointment
Or:
§SMS§ Write an SMS.
If 10 entries are already stored in the list, the
next appointment reminder will delete the
oldest entry.
Setting the alarm clock
Prerequisite: The date and time have
already been set (page 91).
Activating/deactivating the alarm
clock and setting the wake-up time
v ¢
Í
Organizer
¢ Alarm Clock
¤ You can enter data in the following fields:
Status:
Select On or Off.
Time:
Enter the wake-up time in 4-digit format.
Occurrence:
Select Daily or Monday-Friday.
Volume:
Set the volume for the alarm (1–5) or cre-
scendo ring (volume increases with each
ring =
‡).
Signal:
Select the melody for the alarm.
§Save§ Press the display key.
In the idle display header, you see the ¼
icon and the wake-up time.
A wake-up call is signalled on the display
(
¢ page 4) and with the selected ringer.
The wake-up call sounds for 60 seconds.
If no key is pressed, the wake-up call is
repeated twice at five minute intervals and
then switched off.
During a call, the wake-up call is only sig-
nalled by a short tone.
Deactivating the wake-up call/
repeating after a pause
(snooze mode)
Prerequisite: A wake-up call is sounding.
§Off§ Press the display key. The wake-
up call is deactivated.
Or
§Snooze§ Press the display key or any key.
The wake-up call is deactivated
and then repeated after five
minutes. After the second repe-
tition the wake-up call is deacti-
vated completely.
To Next Page
Loading...
