Siemens Gigaset DL500A - Setting Your Own Area Code; Setting the Bases IP Address in LAN

92
Configuring the system settings
Gigaset DL500A / GRC EN / A31008-N3103-T101-1-7619 / settings.fm / 31.08.10
Version 4, 16.09.2005
Setting your own area code
To transfer phone numbers (e.g., in vCards),
it is essential that your area code (interna-
tional and local area code) is saved on the
base.
Some of these numbers are already preset.
v
¢
Ï
Settings
¢ Telepho ny
¢ Area Codes
Check that the (pre)set area code is correct.
¤ You can enter data as follows:
q Select/change input field.
r Navigate in the input field.
Ñ If necessary, delete number:
Press the display key.
~ Enter number.
§Save§ Press the display key.
Example:
Setting the base's IP address
in LAN
Prerequisite: Your base is connected to a
router or a PC (
¢ page 15).
An IP address is required in order for the LAN
to "recognise" your base.
The IP address can be assigned to the base
automatically (by the router) or manually.
u If done dynamically, the router's DHCP
server automatically assigns an IP
address to the base. The base's IP address
can be changed according to router set-
tings.
u If done manually/statically, you assign a
static IP address to the base. This may be
necessary depending on your network
configuration (e.g., if your base is con-
nected directly to a PC).
You can also make local network settings via
the Web configurator.
v
¢ Ï Settings ¢ System
¢ Local Network
~ Enter the current system PIN if
necessary and press
§OK§.
¤ You can enter data in the following fields:
IP Address Type
Select Static or Dynamic.
For IP Address Type Dynamic:
The following fields show the current set-
tings that the phone obtained from the
router. These settings cannot be
changed.
For IP Address Type Static:
You must manually define the IP address
and the subnet mask for the base in the
following fields, as well as the standard
gateway and DNS server.
Please note
It is especially necessary to set the inter-
national code if you connect a GSM
mobile to the base via Bluetooth. Phone
numbers transferred from the GSM net-
work always include the international
access code, even for calls within a coun-
try.
If, for example, you later wish to call back
the caller from a call list via one of your
phone's connections, the international
code is withheld for national phone calls.
Area Codes
International code:
00 - 30
Local area code:
0 - [ ]
Info Save
Please note
To assign the IP address dynamically, the
DHCP server on the router must be acti-
vated. Please also read the user guide for
your router.