81
Connecting/using other devices
Gigaset DL500A / GRC EN / A31008-N3103-T101-1-7619 / HS_and_other_Devices.fm / 31.08.10
Version 4, 16.09.2005
Accepting/transferring calls on the
headset
Prerequisite: Bluetooth is activated; a con-
nection has been established between the
Bluetooth headset and the base
(
¢ page 77).
u You are talking on the base or
u You are trying to connect to another
party or
u A call is being signalled on the base
¤ Press the Headset function key on the
base to accept the call on the headset.
Calling
¤ Enter the phone number on the base and
press the Headset function key on the
base.
Using data devices
Prerequisite: Bluetooth is activated.
The data device is in the list of known
devices (marked with õ,
¢ page 78)
or temporarily connected to the base
(
¢ page 80).
You can establish a Bluetooth connection to
the base using a PC, PDA or even a mobile (as
a data device).
You can then, for example, exchange direc-
tory entries with the data device in the form
of vCards, compare the PC's directory with
the directory on the base, load ringer set-
tings or screensavers from the data device to
the base's resource directory or use AT com-
mands to make outgoing calls and accept
incoming calls.
The phone is supplied with QuickSync soft-
ware for the PC (
¢ page 106). You will find
it on the enclosed CD.
QuickSync provides PC functions via a
graphical interface.
Using GSM mobiles (Link2mobile)
You can conduct calls on your base and/or a
registered handset via the GSM connection
on your Bluetooth GSM mobile (call external
parties via the GSM connection on the
mobile or accept calls via the GSM connec-
tion) if the following prerequisites are met:
u Bluetooth mode is activated on the base
and mobile (
¢ page 77).
u Your GSM mobile has been registered
(
¢ page 77) on the base and activated
(
¢ page 79).
u There is a Bluetooth connection estab-
lished between the base and mobile.
u The mobile is in range of the base (less
than 10 m).
u For outgoing calls: The mobile connec-
tion is assigned to the base as a send
connection, or the base can select the
GSM connection as a send connection
(see below).
u For accepting incoming calls: The GSM
connection is assigned to the base as a
receive connection (see below).
A connection is automatically established
between the base in Bluetooth mode and
the activated mobile in range:
u If a call arrives via the mobile's GSM con-
nection (
¢ page 28)
u If you attempt to make a call on the base
via the GSM connection (
¢ page 27)
If Bluetooth mode is deactivated on the
base:
¤ Open the list of known devices.
¤ Select the activated mobile (marked
with μ).
¤ Press the display key §Options§.
¤ Select Connect Mobile and press §OK§.
Please note
For instructions on adjusting the speak-
ing volume on your headset,
¢ page 87.
Please note
For instructions on sending vCards to a
Bluetooth device or receiving them from
a Bluetooth device, see page 41.
To Next Page
Loading...
