Siemens Gigaset DX800A - Specifications; Writing and Editing Text

154
Appendix
Gigaset DX800A all in one / GRC EN / A31008-N3100-T101-1-7619 / appendix.fm / 31.08.10
Version 4, 16.09.2005
Specifications
Power consumption of the base
General specifications
Pin connections on the fixed line
telephone jack
Writing and editing text
The following rules apply when writing text:
u Each key between Q and O is
assigned several letters and characters.
u Control the cursor with uvts.
Press and hold u or v to move the cur-
sor word by word.
u Characters are inserted to the left of the
cursor.
u Press the star key
*
to display the table
of special characters. Select the required
character and press the display key
§Insert§
to insert the character at the cursor posi-
tion.
u Press and hold Q to O to enter digits.
u Press display key Ñ to delete the char-
acter to the left of the cursor. Press and
hold to delete the word to the left of the
cursor.
u The first letter of the name of directory
entries is automatically capitalised, fol-
lowed by lower case letters.
In idle status Approx. 3.6 W
During a call Approx. 4.3 W
Interfaces ISDN, analogue fixed line,
Ethernet, Bluetooth
DECT standard Supported
GAP standard Supported
No. of channels 60 duplex channels
Radio frequency
range
1880–1900 MHz
Duplex method Time multiplex,
10 ms frame length
Channel grid 1728 kHz
Bit rate 1152 kbit/s
Modulation GFSK
Language code 32 kbit/s
Transmission power 10 mW, average power per
channel
Range (handsets) up to 300 m outdoors,
up to 50 m indoors
Power supply 230 V ~/50 Hz
Environmental con-
ditions for operation
+5°C to +45°C, 20% to
75% relative humidity
Dialling mode DTMF (tone dialling)
Codec G.711, G.726, G.729AB with
VAD/CNG, G.722
Quality of Service TOS, DiffServ
Protocols DECT, GAP, SIP, RTP, DHCP,
NAT Traversal (STUN), HTTP
1a
2unused
3unused
4unused
5unused
6unused
7unused
8b
4
2
1
6
7
8
3
5