25
First steps
Gigaset DX800A all in one / GRC EN / A31008-N3100-T101-1-7619 / starting.fm / 31.08.10
Version 4, 16.09.2005
Your VoIP provider has supplied you
with an authentication name/pass-
word and, where applicable, a user
name:
¤ Press the key below §No§ on the dis-
play screen.
¤ For further information, please see
"Downloading VoIP provider
data" (
¢ page 27).
You have received an auto-configura-
tion code (activation code) from your
VoIP provider:
¤ Press the key below §Yes§ on the
display screen.
¤ For further information, please see
"Entering the auto configuration
code" (
¢ page 26).
No Internet connection:
The phone requires an Internet connection for you to register your telephone
with a VoIP provider. If a connection cannot be made, one of the following mes-
sages is displayed:
u If the phone cannot establish a connection to the router, the message
IP address not available. is displayed.
Check the plug connection between the router and the base and check the
settings on the router.
Your phone is preconfigured for dynamic assignment of the IP address.
In order for your router to "recognise" the phone, dynamic IP address assign-
ment must also be activated on the router i.e., the router's DHCP server must
be activated.
If the DHCP server cannot or should not be activated, you must assign a fixed
IP address to the phone (
¢ page 134).
u If the phone cannot establish a connection to the Internet, the message
Internet connection not available is displayed.
The IP server may be temporarily unavailable. In this case, try to make a con-
nection again later.
Otherwise: check the plug connection between the router and the modem
or DSL connection and check the settings on the router.
¤ Press §OK§; the IP wizard is closed.
You will then need to call up the wizard later via the menu to configure the
IP connection.
To Next Page
Loading...
