87
Sending SMS (text messages)
Gigaset DX800A all in one / GRC EN / A31008-N3100-T101-1-7619 / sms_BRD_neutral.fm / 31.08.10
Version 4, 16.09.2005
Deleting the incoming list
All new and old SMS messages in the list are
deleted.
¤ Open the incoming list.
§Options§ Open menu.
Delete List Select, press §OK§ and confirm
with
§Yes§. The list is deleted.
Reading or deleting SMS messages
¤ Open the incoming list, then:
q Select SMS.
§Read§ Press the display key. The text is
displayed. Scroll line by line
using q.
Or delete the SMS with
§Options§ ¢ Delete Entry ¢ §OK§.
After you have read a new SMS, it is given the
status "Old" (is no longer shown in bold).
Changing the character set
If you cannot see any text or symbols, the
SMS may have been written with a different
character set (Cyrillic, Greek etc.).
¤ Read the SMS
§Options§ Press the display key.
Character Set
Select and press
§OK§.
s Select character set and press
the
§Select§ display key (Ø = on).
The text is shown in the selected character
set. The setting only applies to the current
SMS.
Replying to or forwarding SMS
messages
¤ Read the SMS
§Options§ Press the display key.
You have the following options:
Reply
Write and send a new SMS to the sender
(page 84).
Edit
Edit the text in the SMS and return it to
the sender (page 84).
Forward
Forward the SMS to another number
(page 84).
Copying the number to the
directory
Copying the sender's number
¤ Open the incoming list and select the
SMS (
¢ page 86).
§Options§ ¢Copy to Directory
¤ Complete the entry (¢ page 71).
Copying/dialling numbers from
an SMS
¤ Read the SMS and scroll to the telephone
number.
The digits are highlighted.
Ó Press the display key.
Complete the entry (
¢ page 71).
Or:
c Pick up the receiver to dial the
number.
If you wish to use the number to send an
SMS:
¤ Save the number with the local area code
(dialling code) in the directory.
If an SMS contains several numbers, the next
number will be highlighted if you scroll
down until the first number disappears from
the display.
Please note
An attached mailbox identifier is added
to the directory.
Please note
u The + symbol is not transferred for
international area codes.
¤ You should then enter '00' at the
start of the number.
u If there are no more entries available
in the directory, you can only over-
write or modify an existing entry.
To Next Page
Loading...
