Siemens Gigaset S810A - Initial charging and discharging of the batteries

16
First steps
Gigaset S810-S810A / Grossbritannien / A31008-M2306-L101-1-7619 / starting.fm / 18.03.2011
Version 4.1, 21.11.2007
Initial charging and discharging of the batteries
The correct charge status can only be displayed if the batteries are first fully
charged and discharged.
¤ Charge the handset in the base for 8.5 hours.
¤ After charging, remove the handset from the base and only replace it when the
batteries are fully discharged.
Please note
The handset must only be placed in the designated Gigaset S810/S810A base or
charging cradle.
8.5 h
Please note
u Each handset is registered with the base at the factory. You do not need to
register the handset again. If you wish to use your handset with a different
base or use further handsets with your base, you will need to register the
handset manually (
¢ page 62).
u After the initial battery charge and discharge, you may place your handset in
the base after every call.
u Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
u The batteries may warm up during charging. This is not dangerous.
u After a while, the charge capacity of the batteries will decrease for technical
reasons.