81
Gigaset S810-S810A / Grossbritannien / A31008-M2306-L101-1-7619 / appendix.fm / 18.03.2011
Version 4.1, 21.11.2007
Questions and answers
If you have any questions about the use of
your phone, you can contact us 24/7 at
www.gigaset.com/service
.
The table below contains a list of common
problems and possible solutions.
Registration or connection problems with a
Bluetooth headset.
¥ Reset the Bluetooth headset (see the user
guide for your headset).
¥ Delete registration data from the handset
when deregistering the device (
¢page 68).
¥ Repeat the registration process (¢ page 68).
The display is blank.
1. The handset is not switched on.
¥ Press and hold the end call key a.
2. The battery is empty.
¥ Charge the battery or replace it
(
¢page 14).
Not all menu items are displayed.
The menu display is restricted (standard mode).
¥ Activate extended menu display
(expert mode
•
) (¢page 28).
No Base flashes on the display.
1. The handset is outside the range of the base.
¥ Move the handset closer to the base.
2. The base's range is reduced because
Eco Mode is activated.
¥ Deactivate Eco Mode (¢ page 59) or
reduce the distance between the handset
and the base.
3. The base is not switched on.
¥ Check the base power adapter
(
¢page 12).
Please register handset flashes on the display.
Handset has not been registered with the base or
has been deregistered.
¥ Register the handset (¢page 62).
Handset does not ring.
1. The ringtone is deactivated.
¥ Activate the ringtone (¢page 73).
2. Call divert set for "All Calls".
¥ Deactivate call divert (¢page 36).
3. The phone only rings if the phone number
has been transferred.
¥ Switch on the ringtone for unknown calls
(
¢page 73).
You cannot hear a ringtone/dialling tone from
the fixed line network.
The phone cord supplied has not been used or
has been replaced by a new cord with the wrong
pin connections.
¥ Please always use the phone cord supplied or
ensure that the pin connections are correct
when purchasing from a retailer
(
¢page 12).
The connection always terminates after
approx. 30 seconds.
Repeater activated/deactivated (
¢page 76).
¥ Activate/deactivate the handset
(
¢page 25).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥ Reset the system PIN to 0000 (¢page 77).
Forgotten the system PIN.
¥ Reset the system PIN to 0000 (¢page 77).
The other party cannot hear you.
You have pressed the mute button h. The
handset is "muted".
¥ Reactivate the microphone (¢ page 34).
The number of the caller is not displayed
despite CLIP.
Calling Line Identification is not enabled.
¥ The caller should ask the network provider to
enable Calling Line Identification (CLI).
You hear an error tone when keying an input (a
descending tone sequence).
Action has failed/invalid input.
¥ Repeat the operation.
Watch the display and refer to the user guide
if necessary.
You cannot listen to messages on the network
mailbox.
Your PABX is set for pulse dialling.
¥ Set your PABX to tone dialling.
To Next Page
Loading...
