Siemens Gigaset S810A - ECO DECT; Reducing energy consumption; Reducing radiation; Eco Mode

59
ECO DECT
Gigaset S810-S810A / Grossbritannien / A31008-M2306-L101-1-7619 / registr_sett.fm / 18.03.2011
Version 4.1, 21.11.2007
ECO DECT
You are helping to protect the environment
with your Gigaset S810/S810A.
Reducing energy consumption
By using a power-saving adapter plug, your
telephone consumes less power.
Reducing radiation
The radiation from your telephone is
reduced automatically:
u Handset: The closer the handset is to the
base, the lower the radiation.
u Base station: The radiation is reduced to
virtually zero when only one handset is
registered and the handset is placed in
the base.
You can reduce the radiation from the
handset and base even more by using Eco
Mode.
u Eco Mode
Reduces the radiation of the base station
and handset by 80% - whether you are
making a call or not. Eco Mode reduces
the range of the base station by approx.
50%. Using Eco Mode always makes
sense when a reduced range is sufficient.
Switching off radiation
u Eco Mode+
When you activate Eco Mode+, radiation
(DECT transmission power) from the base
and handset is switched off in the idle
state.
This is also true when multiple handsets
are used, provided the handsets support
Eco Mode+.
Eco Mode / Eco Mode+ can be activated/
deactivated independently of one another
and can also be used with multiple handsets.
The handset must not be placed in the base.
Activate/deactivate Eco Mode /Eco
Mode+:
v ¢
Ï
¢ Eco Mode
¢ Eco Mode / Eco Mode+
§Change§ Press the display key (³=on).
Status displays
Display icon
ÐiÑÒ
|
Signal strength:
– good to poor
– no signal
Ð white Eco Mode deactivated
Ð green Eco Mode activated
¼ white Eco Mode+ activated
(displayed instead of the
reception strength icon
when in idle status)
¼ green Eco Mode and Eco
Mode+ activated
Please note
u With Eco Mode+ activated, press and
hold the talk key c to check that the
base can be reached. You will hear the
dial tone if the base can be reached.
u When Eco Mode+ is activated:
– Call setup is delayed by approx.
two seconds.
– Handset standby time is reduced
by approx. 50%.
u Registering handsets that do not sup-
port Eco Mode+ will cause the mode
to be deactivated on the base and all
other handsets.
u Activating Eco Mode reduces the
range of the base.
u Eco Mode / Eco Mode+ and repeater
support (
¢ page 76) cancel each
other out, i.e., if you use a repeater,
you cannot use Eco Mode or Eco
Mode+.