67
Using Bluetooth devices
Gigaset S810-S810A / Grossbritannien / A31008-M2306-L101-1-7619 / registr_sett.fm / 18.03.2011
Version 4.1, 21.11.2007
When the room monitor function is acti-
vated, the idle display appears as shown
below:
Changing the set destination
number
v ¢ É ¢ Room Monitor
¤ Enter and save number as described in
"Activating the room monitor and enter-
ing the destination number"
(
¢ page 66).
Cancel/deactivate room monitor
Press the end call key a to cancel the call
when the room monitor is activated.
In idle status, press the display key
§Off§ to
deactivate room monitor mode.
Deactivating the room monitor
remotely
Prerequisites: The phone must support tone
dialling and the room monitor should be set
for an external destination number.
¤ Accept the call from the room monitor
and press keys 9 ;.
The room monitor function will deactivate
after the call ends. There are no further room
monitor calls. The other room monitor set-
tings on the handset (e.g., no ringtone) will
remain activated until you press the display
key
§Off§ on the handset.
To reactivate the room function with the
same phone number:
¤ Turn on the activation again and save
with
§Save§ (¢ page 66).
Using Bluetooth devices
Your Gigaset handset can communicate
wirelessly via Bluetooth™ with other devices
using this technology.
Before you can use your Bluetooth devices,
you must first activate Bluetooth and then
register the devices to the handset.
You can register 1 Bluetooth headset to the
handset. You can also register up to 5 data
devices (PCs, PDAs and mobile phones) to
send and receive directory entries as vCards
or exchange data with the computer
(
¢ page 86).
To use the phone numbers, dialling codes
(country and area code) must be stored in
the directory (
¢ page 75).
You will find a description of how to operate
your Bluetooth devices in the user guides for
these devices.
Activating/deactivating Bluetooth
mode
v ¢ ò ¢ Activation
Press§Change§ do activate or deactivate Blue-
tooth mode (³ = activated).
In idle status, the òicon on the handset
shows that Bluetooth mode is activated)
(
¢ page 4).
i à V
07:15
INT 1 22 Oct
Á
Room monitor
0891234567
Off Options
Please note
u You can operate headsets on your
handset that have the headset or
speaker profile. If both profiles are
available, the speaker profile will be
used to communicate.
u It can take up to 5 seconds to create a
connection between your handset
and a Bluetooth headset. This applies
both when a call is accepted using
the headset or transferred to the
headset, and when a number is
dialled from the headset.
To Next Page
Loading...
