76
Setting the base
Gigaset S810-S810A / Grossbritannien / A31008-M2306-L101-1-7619 / registr_sett.fm / 18.03.2011
Version 4.1, 21.11.2007
Setting the base
The base settings are carried out using a reg-
istered Gigaset S810H handset.
Changing the base Gigaset
S810A ringtones
u Volume:
You can choose between five volumes
(0–6; e.g., volume 3 = Š) and the "cre-
scendo" ringtone (6; volume increases
with each ring = ‡).
u Ringtones:
You can select a ringtone from a list of
pre-loaded melodies.
In idle status:
v
¢
Ï
¢ Audio Settings
¢ Ringtones (Base)
¤ You can enter data in the following fields:
r Set volume.
s Scroll to the next line.
r Set melody.
§Save§ Press the display key to save the
setting.
Activating/deactivating
music on hold
v ¢
Ï
¢ Audio Settings
¢ Music on Hold
Press §Change§ to activate or deactivate the
music on hold (³ = on).
Repeater support
With a repeater, you can increase the range
and signal strength of your base. You will
need to activate repeater mode. This will ter-
minate any calls that are in progress at the
time.
Prerequisite: A repeater is registered.
v
¢
Ï
¢ System ¢ Repeater Mode
Press §Change§ to activate or deactivate
repeater mode (³= on).
After activating or deactivating the
repeater, switch your handset off and
on again (
¢ page 25).
Please note
u Eco Mode / Eco Mode+ (¢page 59)
and repeater support cancel each
other out, i.e., if you use a repeater,
you cannot use Eco Mode or Eco
Mode+.
u Encrypted transmission activated at
the factory is deactivated when a
repeater is registered.
To Next Page
Loading...
