EasyManua.ls Logo

Siemens Gigaset SL910 - Charging the Battery

Siemens Gigaset SL910
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6 el en
Gigaset SL910 KURZ-BA System / GRC eng / A31008-M2300-T101-1-8U43 / starting.fm / 4/17/12
Version 4.1, 21.11.2007
Getting started
Charging the battery
The battery is supplied with a partial charge. Please charge it com-
pletely before use.
¤ Charge the handset in the charger for 5 hours.
Please note
The handset must only be placed in the designated charger.
Please note
u The battery is also charged if the handset is connected via a USB connection to a PC with
a power supply of 500 mA.
u The battery may heat up during charging. This is not dangerous.
u After a time, the charge capacity of the battery will decrease for technical reasons.
¤ First insert battery with the contact surface fac-
ing down .
¤ Then press the battery downwards until it
clicks into place.
1
2
¤ First, align the protrusions on the side of the bat-
tery cover with the notches on the inside of the
casing.
¤ Then press the cover until it clicks into place.
1
2
¤ To remove the battery, insert your fingernail
into the notch on the casing and pull the battery
upwards.
To reopen the battery cover to replace the battery:
¤ Insert your fingernail into the notch on the bot-
tom of the battery cover and pull the battery
cover upwards.
5 h

Other manuals for Siemens Gigaset SL910

Related product manuals