Siemens Gigaset SL910A - Connecting the Base with the Phone Network and the Mains Power Supply

13
First steps
Gigaset SL910/910A / GBR/IRL / A31008-M2300-L101-1-7619 / starting.fm / 08.12.2011
Version 4.1, 21.11.2007
Connecting the base with the phone network and the mains
power supply
Please note:
u The power adapter must always be connected, as the phone will not operate
without a power supply.
u Use only the power adapter and phone cord supplied. Pin connections on tele-
phone cables can vary (pin connections,
¢ page 94).
¤ Insert the phone cable (cable
slightly flattened) into the lower
connection socket at the rear
of the base.
¤ Insert the power cable for the
power adapter into the upper
connection socket at the rear
of the base.
¤ Insert both cables into the
appropriate cable channels .
¤ First, connect the power adapter
.
¤ Then connect the phone jack
.
C
B
A
C
A
B
C
B
A
A
B