79
Setting up the base
Gigaset SL910/910A / GBR/IRL / A31008-M2300-L101-1-7619 / settings-pabx.fm / 08.12.2011
Version 4.1, 21.11.2007
Setting up the base
Activating/deactivating music on hold
¤ In the Settings menu (¢ page 25), touch [
ì
Audio Settings].
¤ If necessary, scroll to Music on Hold. ¤ Activate/deactivate music on hold with
the corresponding button.
Repeater support
You can increase the range and signal strength of the base using a repeater. To do
so, you must activate repeater operation. During activation, calls currently taking
place via the base are cancelled.
¤ In the Settings menu (¢ page 25), touch [ Ê System].
¤ Activate/deactivate the repeater operation with the button next to Repeater
Mode.
After activating or deactivating the repeater, switch your handset off
and on again (
¢ page 22).
Changing the system PIN
¤ In the Settings menu (¢ page 25), touch [ Ê System].
¤ Touch the ’ next to System PIN. ¤ Enter the current PIN (default setting: 0000).
¤ Enter the new system PIN (4 digits; 0–9). ¤ Confirm with è.
Resetting the system PIN
If you have forgotten your system PIN, you can reset it to 0000. If you do this, all the
base settings will be reset and all the handsets will be de-registered!
¤ Remove the power cord from the base. ¤ Press and hold the register/paging key
on the base and at the same time reconnect the power cord to the base.
¤ Press and hold the registration/paging key until it begins to flash.
Resetting the base to the default settings
When the settings are restored:
u Date and time are retained
u The redial list is not cleared
u Handsets are still registered
u The system PIN is not reset.
Please note
u If you use a repeater, you cannot use Eco Mode and Eco Mode+.
u The default encrypted transmission setting is deactivated when repeater
mode is activated.
To Next Page
Loading...
