9
Notes
■ Rapid heating is cancelled by adjusting the type of heating.
■ The duration of the programmed cooking time begins to run,
regardless of the rapid heating.
■ The oven temperature reached may be displayed during
heating by pressing on the button
±.
■ To ensure uniform cooking, the food must not be put into the
oven until rapid heating has been completed.
Cancelling rapid heating
Press the
h button. The symbol goes out.
Time functions
The time functions menu is accessed using the button 0. The
following functions are available:
When the oven is off:
■ Q = set the timer
■ 0 = set the time
When the oven is on:
■ Q = set the timer
■ x = set the cooking time
■ y = delay the end time
Setting the time-setting options in brief
1. Press the 0 button repeatedly until the arrow is next to the
required symbol, e.g. set cooking time function =
Nx.
2. Set the desired value with the rotary selector.
3. Press the
0 button repeatedly until the Î rotary symbol
disappears from the clock display.
A detailed description of how to adjust each individual function
is provided below.
Short audible signal
If you cannot change or set a value, you will hear a short
audible signal.
Programming the timer
The timer works independently of the oven.It can be used as a
kitchen timer and programmed at any time.
1. Press the
0 button.
The time function menu opens.The arrow
N is located to the
left of the symbol
Q. The control knob symbol Î on the two
points indicates that the time can be programmed using the
control knob.
2. Set the time for the timer using the control knob.
3. Press the
0 button repeatedly until the control knob
symbol
Î disappears from the time indicator.
The time indicator shows the time elapsed from the set time.
When the time has elapsed
A signal sounds. The time on the timer has reached
‹:‹‹.
Press the
0 button. The display goes out.
Cancelling the timer time
Press the
0 button to open the menu. Turn the timer time back
to
‹:‹‹. Press the 0 button repeatedly until the Î rotary
symbol disappears from the clock display.
Changing the timer time
Open the menu with the
0 button and use the rotary selector
to change the time. Press the
0 button repeatedly until the Î
rotary symbol disappears from the clock display. The menu is
exited. The new time counts down.
Setting the cooking time
When a cooking time is programmed for a dish, the oven stops
automatically when this time has elapsed. The oven will stop
heating.
Prerequisite: a heating type and temperature must be set.
Example in the picture: top and bottom heat configuration
%,
180 °C, cooking time 45 minutes
1. Press the
0 button twice.
The arrow is located in front of the cooking time symbol
Nx.
The control knob symbol
Î on the two points indicates that
the time can be programmed using the control knob.
2. To set the time using the control knob.
3. Press the
0 button repeatedly until the control knob
symbol
Î disappears from the time indicator.
The configuration is applied.
4. If the oven has not been started, press the
† button.
The time indicator shows the time elapsed of the set time.
The cooking time has elapsed
A signal sounds. The oven stops heating.
‹:‹‹ is shown on
the clock display. You can cancel the audible signal earlier by
pressing the
0 button.
To Next Page
Loading...
Need help?
General