Siemens HR678GES6B - 11.1 Filling the water tank; 11.2 Types of steam heating; 11.2.1 Dough proving; 11.2.2 Reheating

en Steam
16
11.1 Filling the water tank
WARNING‒Risk of fire!
Due to the hot surfaces, vapours from flammable li-
quids may catch fire in the cooking compartment (ex-
plosion). The appliance door may spring open. Hot
steam and jets of flame may escape.
▶ Do not pour flammable liquids (e.g. alcoholic drinks)
into the water tank.
▶ Only fill the water tank with water or with the descal-
ing solution we have recommended.
WARNING‒Risk of burns!
The water tank may heat up while the appliance is in
operation.
▶ Wait until the water tank has cooled down from the
previous operation.
▶ Remove the water tank from the tank recess.
Requirement:The water hardness must be set cor-
rectly.
→"Before using for the first time", Page12
1.
Press
⁠.
a The control panel will pop out automatically.
2.
Pull the control panel towards you with both hands
and then push it upwards until it clicks into place
⁠.
3.
Lift the water tank and remove it from the water tank
recess ⁠.
4.
Press down on the water tank lid along the seal to
prevent water from leaking out of the water tank.
5.
Fill the water tank with water up to the "max" ⁠
mark.
6.
Slide the full water tank back into the recess ⁠.
When doing so, make sure that the water tank clicks
into place in the retainers ⁠.
7.
Slowly slide the control panel downwards and then
push it away from you until it is closed completely.
11.2 Types of steam heating
A variety of types of steam heating are available for
which hot steam is used to gently prepare food.
Dough proving
Yeast dough proves considerably more quickly using
this function than at room temperature, and it will not
dry out.
Reheating
The reheating function can be used to warm up food
that has already been cooked, or bread and pastries
from the day before.
Setting the type of steam heating
Note:
Observe the instructions for the types of steam heating:
¡ →"Types of steam heating", Page16
¡ A cooking time must always be set for steam heat-
ing.
Requirement:The water tank has been filled.
→"Filling the water tank", Page16
1.
Press ⁠.
2.
Press "Steaming".
3.
Use the rotary selector to select the required steam
type of heating.
4.
Press the temperature.
5.
Use the rotary selector to set the temperature.
6.
Press the cooking time.
7.
Use the rotary selector to set the cooking time.
8.
Press ⁠ to start the operation.
Note:If the water tank runs dry during operation, a
notification appears in the display. Operation is
stopped.
→"Filling the water tank", Page16
a The appliance starts to heat and the time starts to
count down.
a Once the cooking time has elapsed, an audible sig-
nal sounds. The time shown in the display is zero.
9.
Once the cooking time has elapsed:
‒ Press
⁠ to silence the audible signal manu-
ally.
‒ To set another cooking time, press the cooking
time and use the rotary selector to set the value.