1 - 1
Siemens-Elema AB SPB7-230.812.06 Page 1 of 2 Opdima®
Solna, Sweden Rev. 01 03.03 SPS-UD Installation
General 1
Introduction 1
These instructions describe how to adjust the resolution and the image geometry of
LCD monitor SCD 1897 TFT.
For acquisition workstation software version ASW 2.1, follow the instructions in chapter 2.
For software version ASW 3.1, follow the instructions in chapter 3.
Prerequisites 1
The monitor should be installed according to chapter "Installation of monitor" in document
Installation and Start-Up Instructions (SPB7-230.033.13...).
Time required 1
Approximately 1/2 hour for one CSE.
To Next Page
Loading...
