2 - 1
Siemens-Elema AB SPB7-230.812.06 Page 1 of 2 Opdima®
Solna, Sweden Rev. 01 03.03 SPS-UD Installation
ASW 2.1 2
Adjusting resolution 2
1. Log in as Service.
2. Press Ctrl+Alt+Shift+!
3. The message "Switch to default behaviour?" appears, click on OK.
4. Right click on the screen background and select "New window".
5. Depending on which computer is used, type the following in the xterm window:
Ultra 1: type /usr/sbin/ffbconfig -res 1280x1024x67 and press enter.
Ultra 10: type /usr/sbin/ffbconfig -res 1280x1024x85 and press enter.
6. If the message "Cannot verify that this is a supported resolution..." appears, type y
and press enter.
7. Type exit and press enter to close the xterm window.
8. Log out.
Adjusting image geometry 2
1. Log in as Service.
2. Maximize the Mode Selection window by clicking on the upper right corner.
3. Press the Menu button on the right side of the monitor. A menu for screen settings
is opened.
4. Select Auto (use the menu button to move in the menu).
5. Open the Auto sub menu by pressing the button with an "up" arrow on the right
side of the monitor.
6. Select Auto choose source (use the menu button to move in the menu) and then
press the "up" arrow button to activate.
7. Check that the size of the Mode Selection window corresponds with the active
area of the screen.
8. Press the Menu button on the right side of the monitor to open the menu for screen
settings.
9. Select Others (use the menu button to move in the menu) and then press the "up"
arrow button to activate.
10. Select Status (use the menu button to move in the menu) and then press the "up"
arrow button to activate.
11. Check that the settings are according to the table below:
* any value
12. Minimize the Mode Selection window by clicking the upper right corner again.
Horisontal Vertical
Resolution 1280 1024
Frequency * 85 Hz
To Next Page
Loading...
