5.4.2 Example 2 - Integration of SINUMERIK Operate into a WinCC interface with PDF
Viewer
This example demonstrates electronic production by directly accessing machine
documentation.
● Representation of the setup plan parallel to the tool loading
● Copy & paste from the PDF directly into the tool list
Parallel display of information directly on the machine
Machine OEM-specific HMI using SINUMERIK Integrate Create MyHMI / WinCC
5.4 Examples of the design for OEM-specific operating concepts.
Smart machine tool operation
38 System Manual, 12/2017, 6FC5397-7FP40-0BA0
To Next Page
Loading...
Need help?
General
