Siemens MIDIMASTER Vector User Manual

English 5. OPERATING MODES
G85139-H1751-U529-D1 © Siemens plc 199
9
4/8/99
40
5.7.3 Parameter Settings
Closed loop process control cannot be used unless P201 is first set to 001. Most of the parameters associated with closed loop process
control are shown in Figure 5.7.1. Other parameters which are also associated with closed loop process control are as follows:
P010 (only if P001 = 1, 4, 5, 7 or 9)
P061 (value = 012 or 013)
P220
Descriptions of all closed loop process control parameters are provided in section 6. For detailed information about PID operation, refer
to the application note “Closed Loop Control”, which may be obtained from
http://www.siemens.com/micromaster or a Siemens sales office.

Siemens MIDIMASTER Vector Specifications

General

Brand	Siemens
Model	MIDIMASTER Vector
Category	Media Converter
Language	English