Siemens MOBILETT Plus - Page 31

Installation 2 - 23
Siemens AG SPR8-220.031.04 Page 23 of 30 MOBILETT Plus/ -E/ -HP
Medical Solutions Rev. 04 09.03 CS PS 24
20. Remove the cable tie (pos. 1 / Fig. 29). Then place the cable as shown in Fig. 29.
The cable should run underneath the flat conductor cables attached to board D1.
21. Replace the cable tie (pos. 1 / Fig. 29) and make sure the cables run tightly
together.
22. Remove the cable tie (pos. 1 / Fig. 30).
23. Pin plug K23 is threaded through the hole (pos. 2 / Fig. 30).
24. Replace the cable tie (pos. 1 / Fig. 30). Make sure there is no slack.
25. Connect pin plug K23 to pin plug K23 of the cable of the new power supply unit.
26. Continue installation under section “Final assembly”.
MOB00527
kV
mAs
1
Fig. 29 Placing cable
K9
D1
MOB00528
Fig. 30 Threading cable
1
2