Siemens NCU 7x0.3 PN Series - Page 15

System overview
2.2 System configuration
NCU 7x0.3 PN
Manual, 09/2011, 6FC5397-1EP40-0BA0
15
The following system configuration is only possible with an NCU 710.3 PN possible:
3+
VSLQGOHPRWRU
).
IHHGPRWRUV
).
IHHGPRWRUV
6,180(5,.RSHUDWRU
SDQHOVZLWK7&8
3RZHUVXSSO\
6,1$0,&66
0RWRU0RGXOH
ERRNVL]HFRPSDFW
IRUPDW
,QGXVWULDO(WKHUQHW
6,0$7,&
(7SUR
'5,9(&/L4
6,180(5,.
+7
6,180(5,.
3&8
33'31
33b'b$b31
6,180(5,.
'VO
1&831
6,1$0,&66
&RPEL
352),1(7
Figure 2-2 Example, topology with NCU 710.3 PN
The following components can be attached to the Control Unit:
● SINUMERIK operator panel front with TCU/PCU 50.3 and Machine Control
Panel/Machine Push Button Panel
● SIMATIC thin client (as of firmware V1.4)
● SIMATIC CE panel
● SINUMERIK handheld units
● Distributed PLC I/O via PROFIBUS DP or PROFINET IO
● SINUMERIK I/O modules PP 72/48D PN and PP 72/48D 2/2A PN
● SINUMERIK Analog Drive Interface for 4 Axes ADI 4
● SINAMICS 120 drive system
● Feed and main spindle motors
– 1FT / 1FK / 1FN / 1FW6 / 1FE1 / 2SP1 synchronous motors
– 1PH / 1PM induction motors