Spare Parts/Accessories
10.2 CompactFlash Card
NCU 7x0.3 PN
Manual, 09/2011, 6FC5397-1EP40-0BA0
163
10.2.2 Inserting the CompactFlash card
Procedure
NOTICE
ESD: you must discharge yourself at the cabinet or ground terminal before touching the
CompactFlash Card.
Please proceed as follows:
1. Switch off the power supply.
2. Remove the blanking cover
①.
3. Carefully insert the new CompactFlash Card
② into the slot until it clicks into place. The
marking
③ provided on the CompactFlash Card is used as orientation: the two arrow
heads point to one another. When properly installed, the card does not extend beyond
the housing.
4. Switch the power supply on again.
① Blanking plate
② CompactFlash Card
③ Marking for insertion direction
Figure 10-2 Inserting the CompactFlash card
To Next Page
Loading...
